A novel time-integral type laser energy meter based on anisotropic Seebeck effect

Abstract

We have posed the design of a time-integral type laser energy meter based on anisotropic Seebeck effect for the first time. Anisotropic Seebeck effect is responsible for the laser-induced thermoelectric voltage effect in high temperature superconductor (HTSC) cuprates and colossal magnetoresistance (CMR) manganites thin films grown on tilted single crystal substrates. In this study, for an example, an epitaxial La 2/3Ca 1/3MnO 3 thin film prepared on a tilted LaAlO 3 substrate by standard pulsed-laser deposition (PLD) method is tested with a 1064-nm Q-switched Nd:YAG laser and its 2nd (532 nm), 3rd (355 nm), and 4th (266 nm) harmonics from room temperature to 16 K. The integral of the voltage signal with time shows a good linear relation with the laser energy per pulse in the measured wavelength and temperature range, which confirms the theoretical analysis given in this letter and can be used to design a time-integral type laser energy meter. The sensitivity increases as the film thickness increases or as the thermal diffusion constant decreases, which makes the time-integral type laser energy meter low cost as compared with the peak-voltage type. It operates with fast (nanosecond range) and broad-spectrum (from infrared to ultraviolet) response in wide temperature range (from room temperature to 10s K), and can be useful replacements for pyroelectric power/energy meters.