Abstract
The effects of cyclic mechanical strain and challenge with physiologically relevant doses of submicrometre-size polyethylene (PE) particles on the osteolytic potential of primary human mononuclear phagocytes were investigated. Cells were seeded into a three-dimensional tissue matrix and co-cultured with particles (mean size 0.21 microm) at particle volume to cell number ratios of 7.5, 15, 30 and 100 microm3/cell. Matrices were then either cultured statically or subjected to 20 per cent cyclic compressional strain in the 'ComCell' for 16 h prior to the assessment of cell viability and quantification of the pro-inflammatory cytokine tumour necrosis factor alpha (TNFalpha). The MTT (3-[4,5-dimethylthiazol-2-yl]-2,5-diphenyltetrazdium bromide) assay was shown to be too insensitive to detect changes in cell viability. However, when quantified by the adenosine triphosphate (ATP) assay, cell viability was demonstrated to be reduced following exposure to cyclic strain. Macrophages cultured in the static three-dimensional tissue equivalent model produced very high levels of TNFalpha in response to submicrometre PE particles at a ratio of 100 microm3/cell. Cyclic strain in the absence of particles gave only a small increase in TNFa production. However, the combined effects of strain and particle stimulation at a ratio of 30 microm3/cell resulted in the secretion of significantly more TNFalpha than was produced by macrophages subjected to strain alone, or the cells-only control. This synergy between cyclic strain and PE particle stimulation was only evident when the volume of particles was reduced below the volume that maximally stimulated cells. These results suggest that while cyclic strain may not be the primary factor responsible for macrophage activation and periprosthetic osteolysis, at low particle load, it may contribute significantly to the osteolytic potential of macrophages in vitro or in vivo.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Proceedings of the Institution of Mechanical Engineers. Part H, Journal of engineering in medicine
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.