A novel technique for solving unsteady three-dimensional brownian motion of a thin film nanofluid flow over a rotating surface.

Abstract

The motion of the fluid due to the swirling of a disk/sheet has many applications in engineering and industry. Investigating these types of problems is very difficult due to the non-linearity of the governing equations, especially when the governing equations are to be solved analytically. Time is also considered a challenge in problems, and times dependent problems are rare. This study aims to investigate the problem related to a transient rotating angled plate through two analytical techniques for the three-dimensional thin film nanomaterials flow. The geometry of research is a swirling sheet with a three-dimensional unsteady nanomaterial thin-film moment. The problem's governing equations of the conservation of mass, momentum, energy, and concentration are partial differential equations (PDEs). Solving PDEs, especially their analytical solution, is considered a serious challenge, but by using similar variables, they can be converted into ordinary differential equations (ODEs). The derived ODEs are still nonlinear, but it is possible to approximate them analytically with semi-analytical methods. This study transformed the governing PDEs into a set of nonlinear ODEs using appropriate similarity variables. The dimensionless parameters such as Prandtl number, Schmidt number, Brownian motion parameter, thermophoretic parameter, Nusselt, and Sherwood numbers are presented in ODEs, and the impact of these dimensionless parameters was considered in four cases. Every case that is considered in this problem was demonstrated with graphs. This study used modified AGM (Akbari-Ganji Method) and HAN (Hybrid analytical and numerical) methods to solve the ODEs, which are the novelty of the current study. The modified AGM is novel and has made the former AGM more complete. The second semi-analytical technique is the HAN method, and because it has been solved numerically in previous articles, this method has also been used. The new results were obtained using the modified AGM and HAN solutions. The validity of these two analytical solutions was proved when compared with the Runge-Kutta fourth-order (RK4) numerical solutions.