A novel technique for skull base reconstruction in craniofacial fibrous dysplasia surgery using three-dimensional printing and a dental alginate mold: illustrative case.

Abstract

Fibrous dysplasia is a rare and benign skeletal lesion characterized by fibrous tissue proliferation due to an abnormal osteogenesis replacing normal bone. An 18-year-old male with fibrous dysplasia of the left sphenoid, ethmoid, orbit, and frontal bones was managed with excision and skull base reconstruction. After complete removal of the tumor, skull base reconstruction was commenced by making a reverse temporalis flap and placing it over the opened paranasal sinuses for a robust vascularized graft, followed by an abdominal fat graft, and then a pedicled pericranal flap was added to complete the multilayer onlay graft. To recreate the skull base, a mirror image of the contralateral skull base was constructed using three-dimensional (3D) printing, and the 3D-printed model was sterilized prior to the surgery. Intraoperatively, the model was then pressed onto dental alginate gel to make a negative mold. This was used to make the definitive flap using polymethylmethacrylate. Temporoplasty was also performed using polymethylmethacrylate to fill the defect left by the temporalis graft. The patient recovered well following the procedure. Appropriate, personalized skull base reconstruction techniques can be successfully done with 3D printing using alternative low-cost materials and implements, especially following resection of cases like craniofacial fibrous dysplasia. https://thejns.org/doi/10.3171/CASE24262.