A novel technique for laser-assisted revascularization: an in vitro pilot study.

Abstract

The common limitation of surgical revascularization procedures for severe tissue ischemia due to cardiovascular diseases is the need to interrupt blood flow during the intervention. We aim to introduce a new technique that allows a sutureless, non-occlusive revascularization. A 3-step technique was developed using rabbit's aorta to simulate a side-to-side anastomosis model. It enables the creation of a bypass circuit for revascularization. The first step was the soldering of 2 vessels in a side-to-side fashion based on the laser-assisted vascular anastomosis (LAVA) principle using a diode laser emitting irradiation at 810 nm with an albumin-based solder patch between them, followed by the creation of a channel within the patch using either a holmium-doped yttrium aluminum garnet laser (Ho:YAG) at λ = 2100 nm or a xenon-chloride excimer laser (XeCl) at λ = 308 nm. Thereby, a bypass circuit was created, thus allowing a non-ischemic revascularization. The system was deemed functional when a flow was observed across the anastomosis. The highest average tensile strength recorded after side-to-side LAVA using a diode laser power of 3.2 W for 60 s was 2278.6 ± 800 mN (n = 20). The Ho:YAG laser created the channels with less tension on the anastomosis than the excimer laser. Histological analysis showed limited thermal damage and good patch-tissue adaptation. The preliminary results of this feasibility study outline the foundations for an entirely sutureless laser-assisted revascularization procedure. The next studies will evaluate the rheological parameters across the bypass circuit to optimize the post-anastomotic flow.