Abstract

This paper present a low-cost yet effective localization scheme for the wireless sensor networks. There are many studies in the literature of locating the sensors in the wireless sensor networks. Most of them require either installing extra hardware or having a certain amount of sensor nodes with known positions. The localization scheme we propose in this paper is range-free, i.e., not requiring extra hardware devices, and meanwhile it only needs two anchor nodes with known position. Firstly, we install the first anchor node at the lower left corner (Sink X) and the other anchor node at the lower right corner (Sink Y). Then we calculate the minimum hop counts for each unknown node to both Sink X and Sink Y. According to the minimum hop count pair to Sink X and Sink Y of each node, we can virtually divide the monitored region into zones. We then estimate the coordinate of each sensor depending on its located zone. Finally, we adjust the location estimation of each sensor according to its relative position in the zone. We simulate our proposed scheme and the well-known DV-Hop method. The simulation results show that our proposed scheme is superior to the DV-Hop method under both low density and high density sensor deployments.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.