Abstract
A pre-amplifier for distributed track and hold (DTH) circuit in high speed and high resolution folding and interpolating analog-to-digital converter (ADC) is proposed. This scheme resolves several limitations of conventional differential difference pre-amplifier (DDPA) in low voltage supply, compared to the conventional DDPA, the proposed scheme increases the input range so that all DDPAs of DTH can operate effectively, improves the averaging effect of average network, saves the random offset voltage from device mismatch, decreases the gain error of DTH, reduces the output common-mode (CM) deviation of DTH, and enhances the CM rejection of DTH. Based on SMIC 0.18μm CMOS technology and 1.8V power supply, over the input range, results from spectre shows dummy DDPAs of DTH operate effectively, the offset of output CM voltage of DTH decrease to less than 2mV, gain error decrease to less than 1%, the gain of middle novel pre-amplifier and boundary novel pre-amplifier are both 2.5, bandwidths are all above 1.9GHZ, while power dissipation of each DDPA is 3.22mW. The high CM rejection and low gain error decrease the quantification error effectively, and enhance the performance of ADC. The design meets the requirement of ADC applied to software defined radio (SDR).
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
