Abstract
In this paper, experimental verification of the microstructural evolution model during sintering of aluminum, iron and particulate mullite ceramic powders using self-propagated high-temperature synthesis (SHS) was performed. The powder mixture with 20% wt. content of reinforcing ceramic was investigated throughout this research. The mixed powders were cold pressed and sintered in a vacuum at 1030 °C. The SHS reaction between sintered feed powders resulted in a rapid temperature increase from the heat generated. The temperature increase led to the melting of an aluminum-based metallic liquid. The metallic liquid infiltrated the porous SiO2 ceramics. Silicon atoms were transited into the intermetallic iron–aluminum matrix. Subsequently, a ternary matrix from the Fe–Al–Si system was formed, and synthesis of the oxygen and aluminum occurred. Synthesis of both these elements resulted in formation of new, fine Al2O3 precipitates in the volume of matrix. The proposed microstructural evolution model for growth of ultra-fine Al2O3 oxides from SiO2 silica ceramic decomposition during SHS was successfully verified through scanning electron microscopy (SEM), X-ray energy-dispersive spectroscopy (EDS) analysis and X-ray diffraction (XRD).
Highlights
Intermetallic–ceramic composites (IMCs) are a narrow group of composites used as structural and functional materials
Leaked material was characterized by using scanning electron microscopy (SEM) and chemical composition analysis (EDS), as presented in Figure 2 and Table 1
The performed microstructural characterization and further analysis confirmed the correctness of the proposed model, aimed primarily at obtaining fine precipitates of Al2 O3 oxide reinforcement in the intermetallic matrix of the composite
Summary
Intermetallic–ceramic composites (IMCs) are a narrow group of composites used as structural and functional materials These composites combine unique properties of ceramics (hardness, thermo-chemical resistance and thermal stability) with properties of metals, i.e., mechanical strength. Due to their superior properties, there is a wide spectrum of possible applications for these materials [1]. Composites, in comparison to conventional structural materials, are characterized by a higher Young’s modulus, a low coefficient of thermal expansion, abrasion resistance and high strength. These properties could be maintained during operation at elevated temperatures [2].
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.