Abstract
During virtual three-dimensional orthognathic surgery in cases where an overlap or penetrability occurs between the 2 jaws due to the repositioning of the maxillary segment, it is necessary to establish a vertical opening of the mandible to obtain a relatively good relationship with the maxillary segment for the fabrication of an intermediate occlusal splint. However, there are few reports that address the precise definition of the rotational axis of the mandible during virtual surgery. Here, we present the idea that the mandible's movement during virtual three-dimensional orthognathic surgery is similar to hinge movement in vivo and developed a method for locating the geometric center of the three-dimensional condyle using Hypermesh software combined with Mimics software. Subsequently, we defined the rotational axis of the mandible based on the located geometric centers of the bilateral condyles, and the mandible was then rotated around the defined axis from the retruded contact position to mimic the hinge movement. Preliminary results indicated that the presented method could approximately mimic the hinge movement of the mandible with a relatively high accuracy in a three-dimensional environment, which may improve the accuracy of virtual intermediate occlusal splint.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.