Abstract
The present paper introduces a novel transient experimental method employed to determine the discharge coefficient of constant section nozzles of small diameters of 1–3 mm and with a length/diameter ratio of around one. Flow is considered to be real and compressible; the discharge process was analyzed at relatively high pressures, the fluid used was N2. Based on the experimental data, a generalized expression characterizing the discharge coefficient for nozzles of different diameters, lengths, and fluid conditions was developed. In order to check the precision of the analytical equation presented, experimental upstream reservoir pressure decay was compared with the temporal pressure decay obtained using the new analytical equation. Good correlation was achieved for pressure differentials up to 7.6 MPa. Despite the fact that the procedure established can be extended to other gases and nozzle configurations, so far the equation presented to estimate the discharge coefficient, can only be applied to orifices with length to diameter ratios of around one.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.