Abstract

BackgroundPoint-of-care transthoracic echocardiography (POC-TTE) is essential in shock management, allowing for stroke volume (SV) and cardiac output (CO) estimation using left ventricular outflow tract diameter (LVOTD) and left ventricular velocity time integral (VTI). Since LVOTD is difficult to obtain and error-prone, the body surface area (BSA) or a modified BSA (mBSA) is sometimes used as a surrogate (LVOTDBSA, LVOTDmBSA). Currently, no models of LVOTD based on patient characteristics exist nor have BSA-based alternatives been validated.MethodsFocused rapid echocardiographic evaluations (FREEs) performed in intensive care unit patients over a 3-year period were reviewed. The age, sex, height, and weight were recorded. Human expert measurement of LVOTD (LVOTDHEM) was performed. An epsilon-support vector regression was used to derive a computer model of the predicted LVOTD (LVOTDCM). Training, testing, and validation were completed. Pearson coefficient and Bland-Altman were used to assess correlation and agreement.ResultsTwo hundred eighty-seven TTEs with ideal images of the LVOT were identified. LVOTDCM was the best method of SV measurement, with a correlation of 0.87. LVOTDmBSA and LVOTDBSA had correlations of 0.71 and 0.49 respectively. Root mean square error for LVOTDCM, LVOTDmBSA, and LVOTDBSA respectively were 13.3, 37.0, and 26.4. Bland-Altman for LVOTDCM demonstrated a bias of 5.2. LVOTDCM model was used in a separate validation set of 116 ideal images yielding a linear correlation of 0.83 between SVHEM and SVCM. Bland Altman analysis for SVCM had a bias of 2.3 with limits of agreement (LOAs) of − 24 and 29, a percent error (PE) of 34% and a root mean square error (RMSE) of 13.9.ConclusionsA computer model may allow for SV and CO measurement when the LVOTD cannot be assessed. Further study is needed to assess the accuracy of the model in various patient populations and in comparison to the gold standard pulmonary artery catheter. The LVOTDCM is more accurate with less error compared to BSA-based methods, however there is still a percentage error of 33%. BSA should not be used as a surrogate measure of LVOTD. Once validated and improved this model may improve feasibility and allow hemodynamic monitoring via POC-TTE once it is validated.

Highlights

  • Point-of-care transthoracic echocardiography (POC-TTE) is essential in shock management, allowing for stroke volume (SV) and cardiac output (CO) estimation using left ventricular outflow tract diameter (LVOTD) and left ventricular velocity time integral (VTI)

  • Unlike other methods of hemodynamic monitoring, POC-TTE is non-invasive, allows serial measurements with relatively low resource utilization, and does not expose the patient to ionizing radiation. It is useful for assessing cardiac structure, function, fluid status, as well as hemodynamic monitoring through estimation of stroke volume (SV) and cardiac output (CO) using the SV x the heart rate (HR) [4,5,6]

  • Echo derivation of SV, including measurement of the left ventricular outflow tract diameter (LVOTD) and left ventricular outflow tract velocity time integral (VTI), has shown strong correlation and moderate agreement in both surgical and nonsurgical patients when compared to pulmonary artery catheterization (PAC) [7]

Read more

Summary

Introduction

Point-of-care transthoracic echocardiography (POC-TTE) is essential in shock management, allowing for stroke volume (SV) and cardiac output (CO) estimation using left ventricular outflow tract diameter (LVOTD) and left ventricular velocity time integral (VTI). Unlike other methods of hemodynamic monitoring, POC-TTE is non-invasive, allows serial measurements with relatively low resource utilization, and does not expose the patient to ionizing radiation It is useful for assessing cardiac structure, function, fluid status, as well as hemodynamic monitoring through estimation of stroke volume (SV) and cardiac output (CO) using the SV x the heart rate (HR) [4,5,6]. Using TTE, estimation of hemodynamic variables including CO and systemic vascular resistance (SVR) relies on a relatively simple calculation requiring the patient’s mean arterial pressure, heart rate, height, weight, as well as LVOT VTI and LVOTD The former variables are readily available at the bedside, but the latter require measurement utilizing ultrasonographic Doppler examination

Objectives
Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call