A Novel Method for Quantifying Soil Hydraulic Properties

Abstract

A knowledge of soil hydraulic properties—the water retention curve and unsaturated hydraulic conductivity—is required for soil water modelling and for various studies of soil hydrology. Taking measurements using traditional techniques is time consuming, the equipment is costly and the results can be uncertain. The evaporation method is frequently used for the simultaneous determination of hydraulic functions of unsaturated soil samples, i.e. the water retention curve and hydraulic conductivity function. Due to the limited range of common tensiometers, all the methodological variations of the evaporation method suffer from the limitation that the hydraulic functions can only be determined to a maximum of 70 kPa. The extended evaporation method (EEM) overcomes this restriction. Using new cavitation tensiometers and setting the air-entry pressure of the tensiometer’s porous ceramic cup as a final tension value allow both hydraulic functions to be quantified close to the wilting point. Additionally, soil shrinkage dynamics as well as soil water hysteresis can be quantified. Here, the HYPROP system was selected, a commercial device with vertically aligned tensiometers optimised to perform evaporation measurements. The HYPROP software was developed for recording, calculating, evaluating, fitting and exporting hydrological data. A good match between the results of soil hydraulic functions was shown when those obtained from traditional methods and the extended evaporation method were compared. Systematic deviations were not found.