Year-end Sale % OFF 
Abstract
The paper describes a novel method for updating computer aided design (CAD) models with information taken from physical models in the early stages of design. The new approach is an image mapping based method in which an initial. CAD model is transferred to a soft rapid prototype model (RPM) made by a three-dimensional printer and sculpted in order to carry out formal developments. The RPM has a built-in contrasting three-dimensional grid composed of parallel orthogonal planes, and the initial CAD model is represented by cross-section curves corresponding to the RPM grid. The initial CAD geometry is then updated from images of the developed RPM by matching the differences between the initial CAD model and the modified RPM, making use of identical perspective transformations and viewpoints for the initial CAD model and an RPM image. Examples studied varied from a small depression on a cube face to general freeform surfaces. Compared with typical reverse engineering (RE) processes, the present approach is simpler and more direct. It is not necessary to use three-dimensional scanning or coordinate measuring devices for updating existing initial geometrical CAD models with data obtained from physical models.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
