A Novel Method for Characterizing the Dynamic Behavior of Proppant Pillars With Fracture Closure in Pulse Fracturing

Abstract

Abstract The pulse fracturing is widely used in unconventional reservoirs. It alternately pulse pumping the proppant slurry and clean fluid to form discontinuous placement proppant pillars in the artificial fractures and the pulse fracture conductivity is several orders of magnitude higher than conventional hydraulic fracture conductivity. However, the understanding of the deformation law of proppant pillar under the action of closure pressure and proppant normal stress is unclear, resulting in difficult to calculate the fracture conductivity and prefer proppant. Firstly, replacement construction and experimental displacement by Renault Similarity Criteria, three typical proppant pillars placement structures are extracted through the large-scale visualized flat plate device. The Young's modulus of the proppant pillars are calculated in modified API conductivity cell. Secondly, proppant pillars are dispersed into particles by the Smooth Particle Method (SPH). Using the parameters obtain from the above experiments, fracture-proppant pillar contact models are established to simulate the deformation process of proppant pillar and get normal stress of proppant particles. Thirdly, extracting the shape of stabilized proppant pillars, establish the fracture-proppant pillar flow model, calculate the fracture conductivity in different closure pressure. The simulation results show that as the closure pressure increases from 14MPa to 41MPa, the fracture width present an accelerated downward trend, The fracture width under the support of the initial radius of 9 mm proppant pillars are the largest, decreasing from 2.52mm to 1.72mm, the larger the radius of the proppant pillar, the greater the fracture width, the normal stress of three types of proppant pillar particles are both changed from 73MPa to 110MPa. The elliptical cylinder proppant pillar has the largest fracture conductivity. Its fracture conductivity is reduced from 12500D•cm to 3630D•cm. The larger the construction displacement and the pulse time of proppant slurry, the greater the fracture conductivity. The model in this article can calculate the normal stress of proppant particle and fracture conductivity in different closure pressure, which can significantly guide the choice of construction parameters and the type of proppant.