Abstract
The two-step process of electrodeposition and selenization is one of the most effective methods for producing CIGSe and CZTSe solar cells at a low cost. However, it is difficult to prepare the ultrathin CIGSe absorber by electrodeposition due to the nonuniform deposition of Cu on the Mo substrate. In this study, Cu was deposited on a Sb film instead of a Mo film, and the 3D growth mode of Cu was changed. Uniform and smooth ultrathin Cu films were fabricated on the Sb film using a pulse frequency over a range from 1000 to 10,000 Hz and a pulse current density ranging from 31.25 to 62.5 mA/cm2. Owing to the improved uniformity of Cu/In/Ga films, the thickness of the CIGSe absorber was reduced from 2 to 0.36 μm with Sb incorporation. In addition, the effects of Sb-doping on the CIGSe absorbers and the device performance were investigated. The crystallinity of the CIGSe films was improved, and the interface recombination of the solar cells was reduced by Sb incorporation. Ultimately, CIGSe thin-film solar cells with efficiencies of 5.25 and 11.27% were obtained with CIGSe absorber thicknesses of 0.36 and 1.2 μm, respectively.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
