Abstract
The prime reason for the accidents in the school zone is due to over speeding of the vehicles. The objective of the project is to design and implement a device that controls the speed of the vehicle in required areas. This is to be achieved using the Arduino processor board that is attached in the vehicle. The device consists of two main components, the transmitter and the receiver. The transmitter gets activated during the peak hours and sends the Radiofrequency .The receiver that is attached to the vehicle senses the Radio frequency. This enables the fuel control mechanism by automatically controlling the butterfly valve that is responsible for the amount of fuel pumped into the engine. Simultaneously the countdown timer starts. The speed is maintained till the timer reads zero, after that the vehicle resumes its original state.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
