Abstract
The resistivity anisotropy characteristic of near-tight sandstone reservoirs is important for reservoir evaluation, but it is a challenge to obtain it by using conventional logging curves in vertical boreholes. Thus, a novel evaluation scheme is established. Firstly, in the Chang 8 Formation of Zhenjing area, Ordos Basin, China, horizontal rock samples (parallel to bedding) and vertical rock samples (perpendicular to bedding) are collected for designed rock electricity experiments and analyzed to obtain the corresponding horizontal and vertical Archie's parameters. Secondly, based on the detection characteristics of acoustic logging instrument and the transformation form of the Archie's equation, an estimation method of vertical resistivity is established. Combined with the horizontal resistivity obtained from conventional deep resistivity logs in vertical boreholes, an estimation method of resistivity anisotropy coefficient is proposed. Thirdly, the relationships between resistivity anisotropy coefficients and water saturations and porosities are analyzed using experiment results, and four adjacent vertical wells in the study area are processed using the estimated method. The processed results demonstrate the feasible of the estimation method. In addition, the cross well profile of resistivity anisotropy coefficient in the target formation is characterized, which shows the target formation is slightly resistivity anisotropic and slightly heterogeneous. The relationships between the resistivity anisotropy coefficient and commonly used logs are discussed, which contribute to rapid analyze the resistivity anisotropy of the target formation. Based on the above methods and processes, the novel evaluation scheme of resistivity anisotropy is established, which contributes to quantify and qualitatively analyze the resistivity anisotropy characteristics of formations in and between vertical boreholes. The application results show that it provides an alternative scheme for continuously evaluating the resistivity anisotropy in boreholes and cross well profiles by using conventional logs and experiments.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.