A novel design of silica-based completion nanofluids for heavy oil reservoirs

Abstract

The main objective of this manuscript is the design of completion nanofluids (NanoCF) using silica nanoparticles based on the impact on the capillary number for being applied in heavy crude oil reservoirs. Six types of silica nanoparticles with different chemical nature were characterized by dynamic light scattering (DLS), point of zero charge (pHpzc), Fourier transform infrared spectroscopy (FTIR), transmission electron microscopy (TEM), surface area (SBET), X-ray diffraction (XRD) and total surface acidity through temperature-programmed desorption of NH3 (TPD-NH3). Adsorption isotherms were constructed for understanding the non-ionic surfactant interaction with nanoparticles and rock surfaces, showing that a high adsorption affinity of the surfactant onto the rock surface, leaving less than 24% of free surfactant molecules able to migrate to the water/oil interface. Nevertheless, nanoparticle addition onto completion fluids (CF) could reduce the adsorbed surfactant onto the rock surface by 75%, which means more molecules of surfactant at the interface due to the nature of the obtained nanoparticles (NPS). The nanoparticles were selected based on the capillary number, showing that the best material reduced the interfacial tension between heavy crude oil and CF more than 76% and have the capacity to modify an initial oil-wet state to a water-wet rock surface. Finally, a coreflooding test was carried out at reservoir conditions (158 °F and 6.89 MPa) for evaluating the best completion nanofluid design based on the static tests, showing an increase of the oil effective permeability of 37% and incremental oil recovery of 3% in comparison to the completion fluid without nanoparticles. For the first time, novel completion nanofluids could allow stimulating the well from the beginning of the productive life.