Abstract
Due to the existence of line impedances and low-bandwidth communication, the traditional peer-to-peer control method based on droop control has difficult meeting the requirements of current sharing and voltage stability in islanded DC microgrids at the same time. In this paper, a novel current-sharing control strategy based on injected small ac voltage with low frequency and low amplitude is proposed for multiple paralleled DC–DC converters. The small ac voltage is superimposed onto the output voltage of each converter. Then, the reactive circulating power is generated and used to regulate the output DC voltage of each converter. Under the droop characteristic between the injected frequency and output DC current, a feedback mechanism is generated to realize the accurate current sharing. On this basis, a reactive power-voltage limiter link and virtual negative impedance are added. Under the interaction of the two links, the bus voltage drop caused by line impedances can be almost completely eliminated. This method does not need any communication or to change the hardware structure. The controller design process is presented in detail along with a system stability analysis. Finally, the feasibility and effectiveness of the proposed control strategy are validated by the results obtained from simulations and experiments.
Highlights
As an effective means of application of distributed generation technology, microgrid has attracted more and more attention in recent years [1,2,3]
DC microgrids have been preliminarily applied in independent power supply systems such as marine power systems, aerospace systems, and data centers [10,11,12]
In order to overcome the bus voltage drop caused by line impedances, as well as to obtain the current sharing objectives, a novel current-sharing control strategy for multiple paralleled DC–DC converters is proposed
Summary
As an effective means of application of distributed generation technology, microgrid has attracted more and more attention in recent years [1,2,3]. Each generation unit only needs to communicate with its neighboring units, after a certain number of iterations, the target parameters converge to the average value These methods greatly improved the contradiction between power sharing accuracy and bus voltage drop. The small frequency signal was superimposed onto the output voltage of each converter, and the dc output voltage can be adjusted through the reactive power generated by the superimposed ac voltages This method can improve the load current sharing accuracy, but it does not consider the bus voltage drop caused by line impedances. In order to overcome the bus voltage drop caused by line impedances, as well as to obtain the current sharing objectives, a novel current-sharing control strategy for multiple paralleled DC–DC converters is proposed.
Sign-in/Register to view highlights & summary Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
