Abstract
The one-step AM process is considered the goal many researchers seek in the field of Additive Manufacturing (AM) of high-technology ceramics. Among the several AM techniques, only Powder Bed Fusion (PBF) can directly print high-technology ceramics using one step. However, the PBF technique faces numerous challenges to efficiently be employed in the PBF of ceramics. These challenges include the formation of cracks, generated thermal stress, effective laser-powder interaction, and low acquired relative density. This study developed a new preheating mechanism for ceramic materials using two laser systems to surpass beyond these challenges and successfully print ceramics with a single-step AM method. One laser is used to preheat the powder particles before the second laser is utilised to complete the melting/sintering process. Both lasers travel along the same scanning path. There is a slight delay (0.0001 s) between the preheating laser and the melting/sintering laser to guarantee that the melting/sintering laser scans a properly preheated powder. To further facilitate testing of the preheating system, a numerical model has been developed to simulate the preheating and melting process and to acquire proper process parameters. The developed numerical model was shown to determine the correct process parameters without needing costly and time-consuming experiments. Alumina samples (10 × 10 × 6 mm3) were successfully printed using alumina powder as feedstock. The surface of the samples was nearly defect-free. The samples' relative densities exceeded 80%, the highest reported relative density for alumina produced by a single-step AM method. This discovery can significantly accelerate the transition to a one-step AM process of ceramics.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.