A novel and predictive process of manufacturing 3DN C/SiC torque tube

Abstract

In this research, a novel method of CVI + RMI 3DN C/SiC torque tube preparation has been researched. CVI + RMI 3DN C/SiC flat panel was evaluated by Archimedes drainage method for density and open porosity, SEM for morphological characterization, XRD for phase composition characterization, and chemical method for composition mass and volume content. It has an average density of 2.19 g cm−3, and open porosity of 10%. The computed chemical composition method findings are undoubtedly in line with the fiber design volume percentage of 30%. Tensile and shear mechanical tests on 3DN C/SiC standard sample were investigated, with good performance. The average tensile and shear strength was 141.64 MPa and 86.24 MPa respectively. 3DN C/SiC torque tubes were prepared by the same process, and the torsional mechanical tests were carried out. According to the mechanical parameters of the flat panel 3DN C/SiC sample, the mechanical properties of stress distribution and shear stress-strain curves for the torque tube are predicted by using the finite element simulation method, which is in good agreement with the test results. The test and simulation error of the maximum shear strength is only about 2%.