Abstract
Considering the serious inhomogeneous distribution of plastic deformation in the rolling process of thick plate, a novel 2D metal flow model is proposed with a quadratic distribution of flow velocity in the thickness direction instead of an equal value used in traditional metal flow models. According to the energy method, this model is solved. Through comparing with the experimental data of rolling force, the accuracy of this model is validated. Then, it is found that with the increase in roll speed, the neutral point moves towards the exit of the deformation zone. However, compared with other models of metal flow in rolling process, the neutral point is distributed much closer to the entrance of the deformation zone. That is because with the quadratic distribution of flow velocity in thickness direction, flow velocity of metal at the surface increases faster than average flow velocity of metal, so that the neutral point appears earlier.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.