Abstract

In this paper, a non-contact feed microwave metal deformation and stress sensor based on microwave harvesting metamaterial (MHMA) is proposed. It integrates HMA array, feed network and complementary cross finger split-ring resonator detector (CFSRRD). The sensor can be applied in the detection system composed of waveguide antenna (WA at 10GHz) and vector network analyzer (VNA). In processing of monitoring, the signal emitted by WA will be captured by MHMA array and output to CFSRRD through feed network. Then the response signal of CFSRRD will be returned to WA and analyzed by VNA. From analysis results, the deformation information of metal device will be obtained. Combined with the initial conditions of metal devices, the stress mutation information can be further obtained. Simulation and measurement results show that the designed sensor can detect the metal pipeline deformation caused by external force, pressure or high temperature with the reliable accuracy level of 500 μm (Submillimeter Level), and the minimum detectable radius of pipe is 30mm. It has the advantage of simple structure, strong adaptability and overcomes the shortcoming that traditional detection methods are difficult to detect the operating state of metal devices in complex environment.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.