Abstract
We present a new short-open-load-thru (SOLT) calibration method for on-wafer S-parameter measurements. The new calibration method is based on a 10-term error model which is a simplified version of the 16-term error model. Compared with the latter, the former ignores all signal leakages except the ones between the probes. Experimental results show that this is valid for modern vector network analyzers. The advantage of using this 10-term error model is that the exact values of all error terms can be obtained by using the same calibration standards as the conventional SOLT method. This avoids not only the singularity problem with approximate methods, such as least squares, but also the usage of additional calibration standards. In this paper, we first demonstrate how the 10-term error model is developed, and then, the experimental verification of the theory is given. Finally, a practical application of the error model using a 10-dB attenuator from 140 to 220 GHz is presented. Compared with the conventional SOLT calibration method without crosstalk corrections, the new method shows approximately 1-dB improvement in the transmission coefficients of the attenuator at 220 GHz.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Microwave Theory and Techniques
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
