Abstract
Some stainless steel tubes and aluminium alloy tubes, from 5 to 30 mm in inner diameter and about 1 mm in thickness, have many small holes in the side face. Perforating into the tube from outside, burr is certainly produced inside the tube. In general, the tube is so slender that a conventional deburring tool is hardly inserted into the tube deeply, being impossible to deburr. Therefore, a new technology has been considered to deburr inside such a slender tube by a simple technique. In this experiment, Magnetic Abrasive Machining is applied for the precision deburring of the inner surface of the tube. It is shown the burr produced inside the tube can be completely removed using a simple equipment. Moreover, the possibility of the precision edge finishing is confirmed. This paper discusses the process principle by the application of Magnetic Abrasive Machining and a few deburring characteristics.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
