Abstract

A new low-loading HTS Superconductive-Normal (S-N) current switch using a YBCO thin film stripe is introduced in this paper. Low cost 2.45 GHz microwave signal is applied as the triggering method. Two configuration patterns, cavity layout and transmission line layout, have been tested in the experimental environment. Reliable 100 ms S-N switching is observed with transmission line layout where the loading current is set below 5% of the critical current (Ic). This work demonstrates that a high frequency RF signal is an applicable approach for S-N switch development.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.