A new force-depth model for robotic abrasive belt grinding and confirmation by grinding of the Inconel 718 alloy

Abstract

• A new force-depth model for robotic abrasive belt grinding is proposed considering the deformation of the contact wheel. • The mapping relationship between the grinding force and the grinding depth is obtained. • When the grinding depress depth is large, the feed force and the normal force appear obvious secondary pressure peaks. • The grinding force ratio of downgrinding (average 0.668) is smaller than that of upgrinding (average 0.724). Robotic abrasive belt grinding has been successfully applied to the grinding and polishing of aerospace parts. However, due to the flexible characteristics of robotic abrasive belt grinding and the time-varying characteristics of the polishing contact force, as well as the plastic and difficult-to-machine material properties of Inconel 718 alloy, it is very difficult to control the actual removal depth and force of the polished surface, which brings great challenges to robot automatic polishing. Therefore, the relationship between the grinding force and the grinding depth in the robotic abrasive belt grinding is analyzed in detail, the robot machining pose error model considering the deformation of the grinding head is established, and the Inconel 718 alloy machining experiment of the robotic abrasive belt grinding is designed. The mapping relationship between the grinding force and the grinding depth is obtained, and the grinding force ratio in the downgrinding and upgrinding mode is discussed. The experimental and theoretical comparisons results show that with the increase of the grinding depress depth, both the grinding depth and the grinding force show an irregular increasing trend, and the increasing trend of the grinding force (increases by about 344.44%–445.45%) is obviously greater than that of the grinding depth (increases by about 52.94%). When the grinding depress depth is large (greater than 3 mm), the feed direction force and the normal force appear obvious secondary pressure peaks at the beginning and end of grinding, which has not been seen in previous studies. In addition, regardless of whether it is downgrinding or upgrinding, the grinding force ratio decreases with the increase of the depress depth, and the grinding force ratio of downgrinding (average 0.668) is smaller than that of upgrinding (average 0.724). This study provides a reference for robotic abrasive belt grinding, and the surface quality of Inconel 718 alloy of robotic abrasive belt grinding can be further improved through the optimization of force and depth.