Abstract

Neuromuscular fatigue evaluation is widely performed on different muscles through the conventional protocol using maximum voluntary contraction (MVC) with electrical stimuli in the analyzed muscle. In an attempt to use this protocol on elbow extensor musculature, previous studies and pilot studies showed co-contraction effects from antagonist musculature during muscular stimulations. The aim of this study was to propose a new neuromuscular fatigue protocol evaluation on elbow extensor musculature. Twenty participants preformed exercises to induce central (CenFat) and peripheral fatigue (PerFat). Neuromuscular fatigue was evaluated on knee extensor muscles by a conventional protocol that provides Twitch Superimposed (TSK) and Twitch Potentiated (TPK), central and peripheral parameters respectively. For elbow extensor muscles, the protocol used sustained submaximal contraction at 10, 20, 30, 40, and 50% of MVC. The neuromuscular fatigue in upper limbs was identified by Twitch Potentiated (TPE) and multiple Twitch Superimposed (TSE) parameters. Using the relationship between MVC (%) and evoked force, the proposed protocol used several TSE to provide slope, y-intercept and R2. It is proposed that slope, R2, and y-intercept change may indicate peripheral fatigue and the identified relationship between y-intercept and R2 may indicate central fatigue or both peripheral and central fatigue. The results were compared using the non-parametric analyzes of Friedmann and Wilcoxon and their possible correlations were verified by the Spearmann test (significance level set at p < 0.05). After PerFat a decrease in TPE (57.1%, p < 0.001) was found but not in any TSE, indicating only peripheral fatigue in upper limbs. After CenFat a decrease in TPE (21.4%, p: 0.008) and TPK (20.9%, p < 0.001) were found but not in TSK, indicating peripheral fatigue in upper and lower limbs but not central fatigue. A non-significant increase of 15.3% after CenFat and a statistical reduction (80.1%, p: 0.001) after PerFat were found by slope. Despite R2 showing differences after both exercises (p < 0.05), it showed a recovery behavior after CenFat (p: 0.016). Although PerFat provided only peripheral fatigue, CenFat did not provide central fatigue. Considering the procedural limitations of CenFat, parameters resulting from the proposed protocol are sensitive to neuromuscular alteration, however, further studies are required.

Highlights

  • The conventional neuromuscular fatigue evaluation proposed by Merton (1954) comprise the measurement of maximum voluntary contraction (MVC) with local muscular stimulation

  • After central fatigue induction exercise (CenFat), statistical differences were found for TPK between the PREFATIGUE, POSTFATIGUE and both recovery moments

  • CenFat shows statistical differences for MVCK between the PREFATIGUE, POSTFATIGUE and both recovery moments (Table 1). After both CenFat and peripheral fatigue (PerFat), statistical differences were found for Twitch Potentiated (TPE) and several Twitch Superimposed (TSE) between PREFATIGUE, POSTFATIGUE, and both recovery parameters (p < 0.05)

Read more

Summary

Introduction

The conventional neuromuscular fatigue evaluation proposed by Merton (1954) comprise the measurement of maximum voluntary contraction (MVC) with local muscular stimulation. The difference between MVC and the force evoked during electrical stimulation is denominated “Twitch Superimposed” (TS) (Gandevia, 2001). Increases in this parameter are associated with central fatigue (Allen et al, 1995; Gandevia, 2001). In order to measure the peripherical pathway, after TS induction, another muscular stimulation is applied to the relaxed muscle. In this case, the evoked force is “Twitch Potentiated” (TP) (Gandevia, 2001). This protocol is able to provide information on voluntary activation, being an important parameter in sports and the clinical-hospital environment (Shield and Zhou, 2004; Paillard et al, 2005)

Objectives
Methods
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call