Abstract
An effective method for removing selenium (Se) from water is required from the viewpoint of environmental preservation. To establish this method, a cation exchange resin that adsorbed ferric ions was applied as an adsorbent. In this study, the adsorption behavior of Se to the adsorbent was examined by both batch and column methods. The batch experiment confirmed that selenite ions (Se(IV)) are effectively adsorbed but selenate ions (Se(VI)) are hardly adsorbed. To elucidate the adsorption mechanism, the Fe in the adsorbent and the Fe in the adsorbent after the adsorption of Se(IV) were characterized by Fe K-edge X-ray absorption spectroscopy and 57Fe Mӧssbauer spectroscopy. The analytical result of Se K-edge EXAFS spectra for the Se(IV) adsorbed on the adsorbent suggests that Se(IV) are adsorbed specifically to the adsorbent through the formation of Fe-O-Se bonds. The breakthrough curve obtained by the column experiment showed that Se(IV) in 3 tons of synthetic solution containing 0.1 ppm Se can be efficiently removed using a column in which 12.8 g (10.4 cm3) of the adsorbent was packed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
