A multiplexed optical fibre-based extrinsic Fabry-Perot sensor system for in-situ strain monitoring in composites

Abstract

The detection of impact damage in fibre reinforced composites is of significant concern because such damage can reduce the load-bearing ability of the composite. A number of factors can influence the nature and extent of impact damage development in composites including: (a) the type of reinforcing fibre and resin system; (b) the magnitude of the residual (fabrication) stresses; (c) the lay-up sequence; and (d) other factors such as the nature of the impactor, impact velocity, impact energy, temperature, moisture content in the composites, etc. From a structural health monitoring point of view, it is necessary to investigate the distribution of damage through the thickness of the composite. This paper reports on a simple, partially multiplexed optical fibre strain sensor system for in-situ strain and residual strain measurements in a carbon fibre reinforced epoxy composite. An extrinsic Fabry-Perot interferometric (EFPI) sensor design was used along with single-mode fibres. The multiplexing scheme was based on wavelength division via the use of two super luminescent diodes (SLDs) at different wavelengths. A low-cost fibre optic CCD spectrometer was used as the detector. The multiplexing scheme was demonstrated using two EFPI sensors. In principle, a number of EFPI sensors can be multiplexed using the proposed scheme provided that each sensor is illuminated at a specified and different wavelength. The feasibility of detecting the residual strain in the composite was demonstrated successfully at two specified positions within a 16-ply carbon fibre reinforced composite panel. Preliminary results indicated that the sensor system was also capable of detecting the effects of a 3.2 J impact. Excellent correlation was obtained between the EFPI sensor output and that obtained using surface mounted strain gauges.