A modified scan technique for multiple abutment teeth using the trim and lock function

Abstract

ObjectivesTo describe a new protocol for digital scanning of multiple abutment teeth using the trim and lock software tools. MethodsA reverse workflow technique was used. Scanning was performed with the interim restoration in position. The abutment teeth were then trimmed from the scan. The retraction cord or interim restoration from either the first mesial or distal abutment tooth was removed and only that tooth was scanned, allowing the dentist to easily manage gingival displacement and keep the tooth dry from crevicular fluid and saliva. Consequently, the preparation margin remained visible and uncontaminated during the scan. The adjacent abutment teeth detected in the scan were deleted from it, and the scan was then locked using a tool of the scanning software. Next, the retraction cord or interim restoration of the next abutment tooth was removed, and only that tooth was scanned. The procedure was repeated until all prepared teeth were individually scanned. ResultsThe technique presented here facilitated the scanning of multiple abutment teeth in a simple and predictable way by utilizing the trim and lock surface tools of the scanning software and helped in avoiding closure of the gingival crevice. ConclusionsSplitting the scan for a complex case with multiple abutment teeth allows reliable 3D acquisition of the finish line of each abutment tooth. Therefore, this technique simplifies the full-arch intraoral scanning process and can improve treatment efficiency. Clinical SignificanceThe trim and lock tool allows scanning of each prepared abutment tooth separately, transforming a full-arch impression into multiple single scans. This technique helps to easily manage gingival displacement and maintain an uncontaminated and dry preparation margin during the scan.