Abstract
Cycle slip determination plays an important role in high-precision data processing and application of global navigation satellite systems (GNSS). The TurboEdit method consists of the Melbourne-Wubbena (MW) and the geometry-free phase (GF) combination. It can correctly detect and repair cycle slip in most cases. Cycle slip detection (CSD) with GF is disturbed by severe ionospheric delay variations; moreover, CSD or cycle slip repair (CSR) with the MW faces the risk of the disturbance from large pseudorange errors. Hence, cycle slip determination would be difficult under some extreme conditions, e.g., cycle slips occur in low altitude satellite, low sampling rate of dual-frequency observations. To overcome the limitations, a new dual-frequency CSD and CSR method is proposed. The main contents are as follows: (1) compared with the MW method, the Doppler-assisted phase subtraction pseudorange (DAPSP) method that we proposed has no detection blind spot and can effectively reduce the influence of pseudorange noise at high sampling rates; thus, we replace MW by the DAPSP method to improve the detection accuracy. (2) An adaptive threshold model with root mean square (RMS) is established to effectively reduce the missing and false range detection of cycle slip. (3) The sliding polynomial fitting-assisted GF (SPFAGF) is carried out according to the satellite altitude angle. The trend of ionospheric delay and residual multipath effect error between adjacent epochs is extracted and suppressed by SPFAGF. The method combined with DAPSP and SPFAGF (DAPSP-SPFAGF) overcomes the situation that the TurboEdit method cannot effectively detect under extreme conditions. The experimental results of Beidou dual-frequency observation data show that the TurboEdit method and the DAPSP-SPFAGF method can perform CSD and CSR in most cases. At the sampling rate of 1 s, the detection speed of DAPSP-SPFAGF method is significantly faster than TurboEdit method. The number of false positives about CSD is reduced from 68 to 0. At the sampling rate of 30 s and under the condition of the observed satellite altitude angle below 30°, the false alarm rate of the DAPSP-SPFAGF method is 0, but the TurboEdit method’s false alarm rate is 71.2%. So DAPSP-SPFAGF method is prior to the TurboEdit method at the high sampling rates or under extreme conditions, especially it can accurately detect and repair cycle slip and reduce the false positives and false alarm rate.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.