Abstract
Predicting hydrogen sulphide concentration in sewer network through modelling tools will be beneficial for many stakeholders to design appropriate mitigation strategies. However, the hydrogen sulphide modelling in a sewer network is crucially dependent on the hydraulic modelling of the sewer. The establishment of precise hydrogen sulphide and hydraulic modelling however requires detailed and accurate information about the sewer network structure and the model parameters. This paper outlines a novel approach for the development of hydraulic and hydrogen sulphide modelling to predict the concentration of hydrogen sulphide in sewer network. The approach combines the calculation of wastewater generation and implementation of flow routing on the EPA SWMM 5.0 platform to allow hydrodynamic simulations. Dynamic wave routing is used for hydraulic simulations. It is considered to be the best approach to route existing/old sewer flow. The build-up of hydrogen sulphide model includes the empirical models of hydrogen sulphide generation and emission. Trial of the model was conducted to simulate a sewer network in Seoul, South Korea with some hypothetical data. Further analysis on the use of chemical dosing on the sewer pipe was also performed by the model. Promising results have been obtained through the model, however calibration and validation of the model is required. The presented methodology provides a possibility of the free platform SWMM to be used as a prediction tool of hydrogen sulphide generation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have