Abstract
Advances in additive manufacturing technology (AMT) enable the direct fabrication of thermally conductive molds with heat sinks or conformal cooling channels. Although tool steels (e.g., P21, H13, SUS420J2) are popularly used as die materials because of high dimensional stability, tool steels are inefficient for cooling mold dies due to low thermal conductivity. Hence, the adoption of functionally graded tool steel/Cu materials (FGMs) has good potentials for thermally conductive molds to avoid thermal stress concentration while improving thermal conductivity. In this sense, this paper presents a new method for the representation and analysis of conformal cooling channels in molds (injection or blowing) made of functionally graded tool steel/Cu materials. A heterogeneous sweep operation combined with 2D material blending was proposed to construct heterogeneous solid models for conformal cooling channels. In addition, one-dimensional P21/Cu FGMs were fabricated using DMT (laser-aided direct metal tooling). Material properties (such as density, specific heat, thermal conductivity, coefficient of thermal expansion, and hardness) were evaluated to obtain more accurate analysis results and to verify the feasibility of such a multi-functional mold. An example is shown to illustrate the entire representation and analysis procedure.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
