A Method for Indentifying Broken Rotor Bar and Stator Winding Fault in a Low-voltage Squirrel-cage Induction Motor Using Radial Flux Sensor

Abstract

In this paper, a method for detecting broken rotor bar and stator winding fault in a low voltage squirrel-case induction motor using an air-gap flux variation analysis is proposed to develop a simple and low cost diagnosis technique. To measure the leakage flux in radial direction, a radial flux sensor is designed as a search coil and installed between stator slots. The proposed method is able to identify two kinds of motor faults by calculating load condition of motors and monitoring abnormal signals those are related with motor faults. Experimental results obtained on 7.5kW three-phase squirrel-cage induction motors are discussed to verify the performance of the proposed method. Induction motors are widely used electrical machines, for their simplicity of construction and reliability. However, they are subject to failures those may be due to production processes or operating conditions. These unexpected failures cause severe damages in industrial processes. Motor reliability working group have announced that percentage failure in induction motors is typically: stator related (38%), rotor related (10%), bearing related (40%), and others (12%) (1). Recently, many researchers have studied diagnosis techniques to predict motor failures at their incipient stage and decide proper replacement time of induction motors. Most of them are focused on the failure prediction method using abnormal signals of failure patterns of motors from current and vibration signals (2)- (4). Although vibration and current analysis are the most powerful methods for diagnosing motor faults, their sensors are occasionally difficult to install where the environment of industrial field is in poor condition. In addition to this installation problem, there are many low priced low voltage induction motors in the field. Therefore, the diagnosis technique should be easy to install their sensors and low cost comparing to the price of motors. This paper proposes a method for detecting broken rotor bar and stator winding fault in a low voltage squirrel-cage induction motor using a radial flux sensor to develop a simple and low cost diagnosis technique. The sensor is designed as a search coil and installed between stator slots during motor production to measure the leakage flux in radial direction at the air-gap. The proposed method consists of a calculating load condition, finding abnormal signals and monitoring those signals related with motor faults to indentify two kinds of motor failures. To demonstrate the performance of the method, experimental results obtained on 7.5kW three-phase squirrel-cage induction motors are discussed.