Abstract
This paper reports on a passive MEMS-based flow regulator designed to maintain a steady flow during asthma diagnostics. A prototype consisting of six in-plane moving pistons that restrict the flow through six flow orifices has been fabricated from three wafers using standard silicon micromachining. The in-plane design enables relatively large flows and tuning of the flow and pressure range to specific application requirements by changing a wafer thickness. In particular, for FENO asthma monitoring, regulatory guidelines specifies that measurements should be made at steady flow of approximately 50ml/s and within a pressure range of 1–2kPa. Experimental evaluation of the prototype shows that the flow rate is controlled within a dynamic pressure range of 770Pa compared to only 430Pa for a dummy structure and that it can be achieved on a chip measuring only 2mm×2mm×4mm. The evaluation also showed that condensation of exhaled air that expectedly occurs in the flow regulator at room temperature can be eliminated by local heating of the device to 40°C.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
