A mechanical evaluation of the resistance of various interfragmentary wire configurations to torsion.

Abstract

Fourteen interfragmentary orthopedic wire configurations were tested in torsion using a transverse fracture polyvinylchloride pipe model. These models included single and double Kirschner pins with and without orthopedic wire added to the configuration. The orthopedic wire was applied in either an encircling, figure-of-eight (skewer pin), or cruciate pattern. Double Kirschner pins were applied in a mono- or biplanar fashion. An external fixator model was also tested. Stiffness, yield load, safe load, and energy of absorption were measured and calculated for each model. Orthopedic wire added to any configuration increased stiffness. All single pin configurations with orthopedic wire and the external fixator had the highest stiffness. Two Kirschner pins had a higher torsional yield load and safe load than single pin configurations with or without orthopedic wire. The external fixator model had the highest torsional yield load, safe load and energy of absorption of all configurations tested. However, the external fixator was only significantly different in safe load from the 900 biplanar configurations with wire and the cross pin configuration with encircling wire. The 900 biplanar configurations with wire and the cross pin configuration with encircling wire were equally as effective as the external fixator model in yield load and energy of absorption.