Abstract
In electron probe microanalysis where materials are coated with a thin conductive carbon coat before analysis, the X-ray intensity detected from a specimen may be affected to various degrees by the thickness of the carbon coating. Differences in the carbon film thickness between specimens and standards may lead to errors in analytical results, particular for lower energy X-rays. In this study, we demonstrate that the location and the distance of the specimen relative to the carbon tip in the coating chamber can affect the thickness of the carbon film produced on the specimen surface during carbon coating. The closer the specimen is to the carbon tip contacting point, the thicker is the carbon film deposited. A mathematical model to calculate the carbon film thickness at different locations on the coater plate is established, based on the assumption that carbon atoms evaporate from the carbon tip equally in all directions during the coating process. In order to reduce the differences in the carbon coating thickness, we suggest moving the carbon rod to a higher position, moving the thinner samples to the center and thicker samples to the edge of the coater plate, and using a rotating circular coater plate during coating.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.