A low-cost vacuum casting equipment for aluminium alloys

Abstract

Some of the advantages inherent in the vacuum casting technique such as improved mechanical properties and elimination of shrinkage have been replicated in a low-cost design. Melting and vacuum requirements of the equipment were determined based on a furnace capacity of 15 kg of aluminium. Clay-based refractory and insulating bricks were used for furnace construction. The vacuum system was made from locally available materials and designed for efficiency required for vacuum casting. The equipment was used to melt and cast small-sized specimens using the lost-wax technique and compared with green sand and ceramic mould cast specimens. Tensile and shrinkage tests were carried out on all specimens. The results of the tensile tests were 123, 98 and 113 MPa for the vacuum cast, green sand cast and ceramic mould cast specimens, respectively. Furthermore, shrinkage defect which is common to both green sand and ceramic mould casting was eliminated in vacuum casting. The vacuum casting equipment cost an equivalent of about U.S $1000.00 (One thousand dollars) to construct and can be easily scaled-up for large-sized castings by increasing furnace capacity and the size of the moulding flask.