A low-cost self-powered triboelectric nanogenerator sensor for detecting loosening bolt under impact loading

Abstract

Purpose The purpose of this study is to detect the bolt loosening under conditions of impact loading with a low-cost self-powered triboelectric nanogenerator sensor. Design/methodology/approach In this work, an Al/PTFE-based triboelectric nanogenerator (AP-TENG) is used as a sensor. A pendulum impact device and a force hammer were used to apply the impact loads. The bolt status and the applied torque can be monitored under impact loading conditions by using the output voltage results of the AP-TENGs. Findings The output voltage results of the current AP-TENG sensor under five different bolt torques, i.e. from 0.5 to 2.5 N m, were measured. The measurements revealed that a thicker buffer layer significantly contributed to the generation of higher voltages. Besides, the AP-TENG was also used to light ten commercial green LEDs in series, and the brightness of the LEDs was high enough even for the daytime, which showed that it can be used as the alarm device. In addition, a sudden loose test was also carried out, and the obvious voltage spikes can be seen without the external impact. The force hammer impact tests have expanded the application scope of the AP-TENG in the bolt loosening detection. Originality/value The bolt loosening monitoring is important and useful for the safe operation. The application of TENG technology for detecting bolt loosening remains relatively unexplored. In addition, ten commercial green LEDs can be driven by the AP-TENG sensor, which can be used for the early warning of the bolted loosening status. Peer review The peer review history for this article is available at: https://publons.com/publon/10.1108/ILT-06-2024-0216/