A low-cost high-speed digital data acquisition and display system

Abstract

A flexible and inexpensive data acquisition and display system based upon the KIM-1 microcomputer module is described. A simple signal-conditioning circuit and program are shown that will allow events to be counted at rates to 1,000/sec and stored in successive time bins. The program counts events from each of two event detectors and stores the count of each detector in an independent set of time bins. Up to 127 16-bit bins are available to each event detector and bin width can be varied from 1 msec to 1 min. A separate input can be used to time-lock data collection to a specific stimulus allowing poststimulus histograms or IRTs to be collected. The collected data can be sequentially displayed as a decimal number on a built-in LED display and stored for later analysis on an inexpensive audio cassette recorder.