A Liquid Sensor Based on Frequency Selective Surfaces

Abstract

A novel, simple and easy-to-fabricate liquid sensor using frequency-selective surfaces (FSSs) is proposed. The new sensor concept is based on modifying the capacitance between adjacent FSS elements when materials of different electrical characteristics are inserted. The change in capacitance produces a change in resonant frequency. The FSS design consists of a 9 <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$\times $ </tex-math></inline-formula> 9 array of square loops on <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$0.31\lambda \times 0.31\lambda $ </tex-math></inline-formula> square unit cells with trenches between the loops. The trenches are filled with liquids under test (LTUs). The structure operates at 4.6 GHz without any liquid. When liquids are inserted in the trenches, the resonance frequency varies in relation to the dielectric constant of the liquid. This is observed by measuring the transmission coefficient ( <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$S_{21}$ </tex-math></inline-formula> ). Butan-1-ol, ethanol, methanol, propan-2-ol, and xylene are used to demonstrate the sensing function. A maximum sensitivity of 8.65% for xylene was achieved. Furthermore, very low differences were observed between the measured and expected dielectric constant and loss tangent, thus validating the design. The device is inexpensive, compact, and easy to make and scalable for large-area operations in liquid detection for microwave sensing applications. This technique has potential applications in reconfigurable FSS.