Abstract
This paper presents the design and measurements of a 32-Gb/s differential-input differential-output transimpedance amplifier (TIA) employed in dual polarization integrated coherent receivers for 100-Gb Ethernet. A circuit technique is shown that uses a replica TIA to stabilize the operating point of the two shunt-feedback input stages as well as to cancel the dc part of the two complementary input currents and balances their offset. The TIA can be operated in two modes, an automatic gain control mode to retain a good total harmonic distortion (THD) over a wide dynamic range and a manual gain control mode. Electrical as well as optical-electrical characterization of the TIA are presented. It achieves a maximum differential transimpedance of 74 dB $\Omega $ , 33 GHz of 3-dB bandwidth, 12.2 pA/ $\sqrt {\text {Hz}}$ of average input-referred noise current density with the photodiode, 900 mVpp of maximum differential output swing, less than 1% of THD for 600 mVpp differential output swing, and 500 $\mu \text{A}_{\text {pp}}$ differential input current. The linearity of the TIA is furthermore demonstrated with PAM4 measurements at 25 Gbaud. The dual TIA chip is fabricated in a 0.13- $\mu \text{m}$ SiGe:C BiCMOS technology, dissipates 436 mW of power and occupies 2 mm2 of area.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Microwave Theory and Techniques
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
