Abstract
In this paper, a wavenumber–searching method based on time-domain compensation is proposed to obtain the wavenumber of the Lamb wave array received signal. In the proposed method, the time-domain sampling signal of the linear piezoelectric transducer (PZT) sensor array is converted into a spatial sampling signal using the searching wavenumber. The two–dimensional time-spatial-domain Lamb wave received signal of the linear PZT sensor array is then converted into a one-dimensional synthesized spatial sampling signal. Further, the sum of squared errors between the synthesized spatial sampling signal and its Morlet wavelet fitting signal is calculated at each searching wavenumber. Finally, the wavenumber of the Lamb wave array received signal is obtained as the searching wavenumber corresponding to the minimum error. This method was validated on a 2024-T3 aluminum alloy. The validation results showed that the proposed method can successfully obtain the wavenumber of the Lamb wave array received signal, whose spatial sampling rate does not satisfy the Nyquist sampling theorem; the wavenumber error does not exceed 2.2 rad/m. Damage localization based on the proposed method was also validated on a carbon fiber composite laminate plate, and the maximum damage localization error was no more than 2.11 cm.
Highlights
Structural health monitoring (SHM) techniques use sensors integrated in a structure to monitor its overall real–time health status
According to the propagation formula of the Lamb wave and the searching wavenumber, the time-domain sampling signal of the linear piezoelectric transducer (PZT) sensor array is converted into spatial sampling signal
A PZT used as the actuator for Lamb wave excitation is placed at the center point of the cruciform PZT sensor array on the opposite side of the carbon fiber composite laminate plate
Summary
Structural health monitoring (SHM) techniques use sensors integrated in a structure to monitor its overall real–time health status. A wavenumber searching method based on time–domain compensation is proposed to obtain the wavenumber of the Lamb wave array received signal This method only requires that the temporal sampling frequency satisfies the Nyquist sampling theorem; the spatial sampling rate does not need to satisfy the Nyquist sampling theorem. According to the propagation formula of the Lamb wave and the searching wavenumber, the time-domain sampling signal of the linear PZT sensor array is converted into spatial sampling signal. According to the authors’ previous studies [34,35], damage can be localized using the Lamb wave wavenumber-searching method and cruciform PZT sensor array.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have