A laboratory study of internal gravity waves incident upon slopes with varying surface roughness

Abstract

We report a laboratory study on the scattering, energy dissipation and mean flow induced by internal gravity waves incident upon slopes with varying surface roughness. The experiment was performed in a rectangular box filled with thermally stratified water. The roughness of the slope surface, $\lambda$ , defined as the height of a roughness element over its base width, and the off-criticality $\gamma =(\alpha -\beta )/\beta$ , with $\alpha$ and $\beta$ being the angles of the incident wave and the slope, are used as two control parameters. The distribution of energy dissipation in the direction normal to the slope is found to be more uniform in the rough surface cases. Counter-intuitively, both the maximum value in the dissipation profile and the total energy dissipation near the slope are reduced by surface roughness under most circumstances. The measured peak width (the full width at half-maximum of the peaks) of the dissipation profile is found to be broadened significantly in the rough surface cases. We also observed that there exists a non-zero optimal off-criticality ( $\gamma =0.17$ for the present measurement resolution) for the normalized average dissipation and total dissipation, which may be due to the strongest wave energy near the slope at this $\gamma$ . Unlike surface roughness, the off-criticality has a small effect on the distribution of energy dissipation. Moreover, surface roughness is also found to change the structure of the scattering-induced mean flow and enhance its strength. The present study provides new perspectives on how the surface roughness on topographic features influences energy dissipation.