Abstract
AbstractThis work presents a new technique for reaction kinetic studies of liquid phase reactions in a CSTR. By simultaneously varying the reaction temperature (temperature scanning—TS) and reactant feed concentration (composition modulation—CM) while recording the output concentration, the technique allows, through the least‐square fitting of computer‐generated model data to the experimental time‐series, to obtain from a single experiment the reaction orders as well as both Arrhenius parameters. The alkaline hydrolysis of ethyl acetate was chosen to illustrate the technique, assuming a rate law in the form of a simple power law. The set of parameters that resulted in the minimum sum of squared errors was selected. These values were very close to those reported in literature. The technique saves much time and experimental resources.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.