Abstract
A new hybrid system model is developed to evaluate the potentials of a Brayton cycle heat engine for waste heat recovery from a direct carbon solid oxide fuel cell (DC-SOFC). The maximum power density of the proposed system is up to 0.8675 W cm−2, which is approximately 1.8 times as large as that of the single DC-SOFC. Numerical calculations also indicate that the proposed hybrid system is an efficient approach to boost the fuel utilization, and the maximum power density of the proposed system is markedly better than that of the DC-SOFC/thermophotovoltaic cell, DC-SOFC/thermionic generator, and DC-SOFC/Otto heat engine hybrid systems except for the DC-SOFC/Stirling engine hybrid system. The optimum regions for power density, efficiency and operating current density of the proposed system are determined. The higher operating temperature and lower gap between the anode and carbon layer increase the power density and efficiency of the proposed system. Moreover, the higher heat transfer coefficient boosts the power density and efficiency at high current density. The compression efficiency, expansion efficiency and recuperator coefficient significantly affect the power density and efficiency.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.