Abstract
AbstractGaN high electron mobility transistor (HEMT)‐based low noise amplifiers (LNAs) are an integral part of microwave receiver systems to enhance signal‐to‐noise ratio (SNR). The noise of LNA itself becomes critical for systems requiring high SNR, such as imaging and satellite communication systems. This paper discusses the design of a three‐stage LNA operating at the X‐band in the frequency range of 8.0–12.0 GHz. The amplifier's design and small signal, noise, and linearity characterizations are discussed. Stagewise analysis for gain, noise figure (NF), and matching network losses at the design stage results in achieving promising results. The proposed LNA provides a gain of 23.2 dB with dB gain ripple. Its NF is below 1.5 dB, output power at 1 dB gain compression is 16.4 dBm, and third‐order intercept point is 24.7 dBm at 10 GHz. LNA's survivability is validated to input stress as high as 42 dBm. This LNA is the best reported NF and survivability combination in the 8.0–12.0‐GHz frequency range. The reverse recovery time of LNA is measured under two different pulse conditions, and it has been shown that LNA has better recovery times for lower pulse width signals. This LNA finds its applications in radars and satellite communication systems.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
