Abstract

The flexible supercapacitors (SCs) of the conventional sandwich-type structure have poor flexibility due to the large thickness of the final entire device. Herein, we have fabricated a highly flexible asymmetric SC using manganese dioxide (MnO2) and reduced graphene oxide (RGO) nanosheet-piled hydrogel films and a novel bacterial cellulose (BC)-filled polyacrylic acid sodium salt-Na2SO4 (BC/PAAS-Na2SO4) neutral gel electrolyte. Apart from being environmentally friendly, this BC/PAAS-Na2SO4 gel electrolyte has high viscosity and a sticky property, which enables it to combine two electrodes together. Meanwhile, the intertangling of the filled BC in the gel electrolyte hinders the decrease of the viscosity with temperature, and forms a separator to prevent the two electrodes from short-circuiting. Using these materials, the total thickness of the fabricated device does not exceed 120 μm. This SC device demonstrates high flexibility, where bending and even rolling have no obvious effect on the electrochemical performance. In addition, owing to the asymmetric configuration, the cell voltage of this flexible SC has been extended to 1.8 V, and the energy density can reach up to 11.7 Wh kg−1 at the power density of 441 W kg−1. This SC also exhibits a good cycling stability, with a capacitance retention of 85.5% over 5000 cycles.

Highlights

  • The rapid development of flexible and wearable electronics highly demands flexible energy storage devices [1,2,3,4]

  • As these gel electrolytes are modified from aqueous electrolytes by adding highly viscous and dissolvable polymers, they have the same drawback of the narrow potential window as most aqueous electrolytes, which cannot meet the demands of commercial SCs [11,12]

  • The colloidal suspension of reduced graphene oxide (RGO) was obtained by directly reducing the graphene oxide in the ammonium solution with hydrazine [46]

Read more

Summary

A Highly Flexible Supercapacitor Based on

Haojie Fei 1, *, Nabanita Saha 1 , Natalia Kazantseva 1 , Robert Moucka 1 , Qilin Cheng 1,2 and. Key Laboratory for Ultrafine Materials of Ministry of Education, School of Materials Science and Engineering, East China University of Science and Technology, Shanghai 200237, China

Introduction
Experimental
Fabrication of the Flexible SC Devices
Characterization
Results and Discussion
XRD patterns ofMnO
87 F gcalculated from the profiles
Conclusions
Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.