Abstract
This paper presents the design, fabrication and complete characterization of a high-sensitivity polyimide-based humidity sensor for monitoring internal humidity level in anodically bonded hermetic micropackages. This capacitive sensor is 1 mm on a side and utilizes CU1512 polyimide film with a thickness in the range from 300 /spl Aring/ to 1200 /spl Aring/ sandwiched between two metal electrodes to sense moisture. The measured sensitivity for a sensor with a 1200-/spl Aring/-thick film is 0.86 pF/%RH, and for a 300-/spl Aring/-thick sensor is 3.4 pF/%RH. The sensor has been exposed to and survived a one-hour test at 400/spl deg/C, which is the temperature typically used to perform anodic bonding. Measurements show a drift of less than 1% RH at 50% RH and 37/spl deg/C for 48 h, and a hysteresis of <2% RH over a range from 30 to 70% RH for a 1200-/spl Aring/-thick polyimide film sensor. The measured breakdown voltage of the sensor (1200 /spl Aring/ thick) exceeds 20 V and agrees well with other results.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
